1
Upload footage
Add one video of the machine running — this drives the analysis. You can also attach photos, thermal images, or route sheets as supporting evidence for the report.
Drop files here or click to browse
Video (MP4, MOV, WebM) required · images and other files optional · nothing leaves your device except the AI report step
2
Mark measurement points
Scrub to a sharp frame, then use "Add point" and drag a box around a high-contrast tracking target — repeat for up to three axes (Horizontal, Vertical, Axial) at the same bearing.
No measurement points yet — click "Add point" above.
Sets the vibration-velocity zone boundaries used for the severity gauge.
If your phone stretches slow-motion clips on playback, set this to (capture fps ÷ playback fps). Leave at 1 if unsure.
3
Run the analysis
VibroVision AI samples motion at every marked point in a single pass over the clip and converts each into a frequency spectrum.
Upload a video and mark at least one point above to enable this.
Sampling frames…
4
AI diagnostic report
Generates a structured report from your results. Works offline using a rule-based draft, and can be enhanced with an AI-written narrative when connected.
Vibration Screening Report
VibroVision AI
Generated by VibroVision AI from user-supplied video. Indicative screening only — not a substitute for calibrated vibration measurement or a qualified analyst's on-site assessment.
Session history
No saved analyses yet.